Chapter 2 TL1 Command Syntax and Description
Retrieve NTP Information (RTRV-NTP-PEER)
114 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
Retrieve NTP Information (RTRV-NTP-PEER)
This command retrieves the NTP Peer information for up to 8 peers. The data
includes the information server IP address, the stratum level of the server, the
server LI (in decimal format), the root dispersion value, and the root delay value.
This command has a default access level of USER.
Syntax
RTRV-NTP-PEER:[<tid>]::[<ctag>];
Command Output
The following shows the event output format of the command. Table 2-25 describes
the fields in the response.
Event Response Format
<cr><lf><lf>
sid date time<cr><lf>
M ctag COMPLD<cr><lf>
"<ip1>,<stratum>,<status>,<precision>,<delay>,<offset>,<dispersion>,
<jitter>"<cr><lf>
"<ip2>,<stratum>,<status>,<precision>,<delay>,<offset>,<dispersion>,
<jitter>"<cr><lf>
.
.
"<ip8>,,<stratum>,<status>,<precision>,<delay>,<offset>,<dispersion>,
<jitter>"<cr><lf>
;
Example
To retrieve the NTP peer information from the TimeProvider:
Input
RTRV-NTP-PEER:::TP-1100;
Table 2-25. RTRV-NTP-PEER Output Fields
Field Description
ip The IP address of the NTP server.
stratum The stratum level of the NTP server.
status The status of the NTP server, as described in RFC 1305 Appendix B.
precision The precision value of the NTP server.
delay The client’s calculated root delay value for the NTP server.
offset The client’s calculated time offset value for the NTP server.
dispersion The client’s calculated root dispersion value for the NTP server.
jitter The client’s calculated network jitter.
To Next Page
Loading...
Need help?
General
