097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 139
Appendix A TL1 Command by Function
This appendix lists the TL1 commands by function: Table A-1 contains security and
administrative commands, Table A-2 contains system commands, and Table A-3
contains performance monitoring commands. Refer to Chapter 2, TL1 Command
Syntax and Description for detailed information.
Table A-1. Security and Administrative Commands
Command Description
Activate Feature
(ACT-FEATURE), on page 27
Activates the NTP feature in the TimeProvider
Activate User (ACT-USER), on
page 34
Logs the specified existing user onto the system, and begins a
user session
Retrieve User (RTRV-USER), on
page 128
Lists all users that are currently logged onto the TimeProvider
Cancel User (CANC-USER), on
page 35
Terminates the specified user’s session, and logs the user out
of the system
Enter Password (ENT-PID), on
page 63
Allows a security-level user to edit any user’s password in the
user database
Edit Password (ED-PID), on
page 54
Allows users to edit their own password in the user database
Enter User Security
(ENT-USER-SECU), on page 64
Enters a new user in the user database
Retrieve User Security
(RTRV-USER-SECU), on
page 129
Displays the access level of the specified user, or the access
level of all users
Edit User Security
(ED-USER-SECU), on page 62
Changes the specified user’s access level
Delete Security (DLT-SECU), on
page 39
Deletes all of the information from the user database
Delete User Security
(DLT-USER-SECU), on page 40
Allows a security-level user to delete any user in the user list
Retrieve Command Security
(RTRV-CMD-SECU), on page 85
Retrieves the access level set for a specified command, or all
commands
Edit Command Security
(ED-CMD-SECU), on page 42
Changes the access level of the specified command
Activate Software Download Mode
(ACT-SWDL), on page 28
Places the information management card (IMC) in the firmware
download mode prior to a firmware download
To Next Page
Loading...
