Chapter 2 TL1 Command Syntax and Description
Edit Sync (ED-SYNC)
56 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
Table 2-6. ED-SYNC – Keywords and Values
<keyword> <value> Description Default
<aid> = SYS
CLRDELAY 0 – 1000 The time, in seconds, that elapses after a signal fault
clears and before the associated alarm condition
clears. This delay helps prevent an alarm from
clearing before the signal is stable.
5
FLTDELAY 1 – 15 The time, in seconds, that elapses after an LOS, AIS,
or OOF fault occurs and before the associated alarm
condition is set. This delay helps prevent spurious
alarms.
5
REFMODE AUTO The system automatically selects the reference input
based on the QLEVEL and PRIORITY settings.
AUTO
FORCED Input reference selection is determined by the
INPREF parameter setting.
INPREF GPS The GPS input is selected as the reference when
REFMODE=FORCED.
PRS
PRS The PRS input is selected as the reference when
REFMODE=FORCED.
INP1 Input 1 is selected as the reference when
REFMODE=FORCED.
INP2 Input 2 is selected as the reference when
REFMODE=FORCED.
Note:
When INPREF is used as a keyword with the RTRV-SYNC
command, the input that is currently selected as the system
reference is returned.
CCALIGN NA Allows the user to clear an INPTRR alarm against the
current reference by forcing the CC output into
polarity alignment with the reference. This is a
non-persistent value; when the alignment is
complete, the value returns to its previous value.
NA
To Next Page
Loading...
Need help?
General
