Chapter 2 TL1 Command Syntax and Description
Edit Equipment (ED-EQPT)
46 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
<aid>
cont’d
E422g The command’s effect is on the EIA-422 output group
specified by g:
g = “A” for the group marked “A” on the main shelf
g = “B” for the group marked “B” on the main shelf
g = “C” for the group marked “C” on the main shelf
g = “D” for the group marked “D” on the main shelf
Table 2-5. ED-EQPT – Keywords and Values
<keyword> <value> Description Default
<aid> = SYS
INACTTIME 100 –
10000
The amount of user command inactivity time to be set.
This determines the amount of inactivity time before the
user is automatically logged off of the system.
The range for time is 100 to 10000 in increments of 0.1
seconds. A value of 0 disables automatic logoff.
0
LOGECHO ENABLE Login and logout events are echoed to the local terminal
and stored in the event log.
ENABLE
DISABLE Login and logout events are not echoed to the local
terminal and are not stored in the event log.
<aid> = COML | COMR | COMI
AOMERGE ENABLE Autonomous messages are displayed in the current
session.
ENABLE
DISABLE Autonomous messages are not displayed in the current
session.
ECHO ENABLE Input is echoed to the local terminal. DISABLE
DISABLE Input is not echoed to the local terminal.
TIDQUIET ENABLE The TID is not echoed in response messages. DISABLE
DISABLE The TID is echoed in response messages.
Parameter Value
Description
See
Table 2-5
for <keyword> and <value> descriptions.
To Next Page
Loading...
Need help?
General
