Symmetricom TimeProvider 1100 Reference Guide

Appendix C Events
158 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006
FLOW The IMC serial port flow
control has changed
EQPT NONE  NONE – No flow control
 SW – Software flow control
XON/XOFF
 HW – Hardware flow control
CTS/RTS
 SWHW – Use both types of
flow control
FWFAIL The firmware upgrade of
IMC was unsuccessful.
The firmware upgrade of
the IOC was unsuccessful.
EQPT NA NA
FWOK The firmware upgrade of
IMC was successful. The
firmware upgrade of the
IOC was successful.
EQPT NA NA
IMCBIST The user has requested
the IMC to perform a
Built-in Self Test.
EQPT NA
 PASSED – test(s) passed
 FAILED – test(s) failed
INACTTIME Set the communication
inactivity timeout. If no
user command is entered
within the specified time
the user’s session is
terminated.
EQPT 0 (no timeout)
 0 = Disable timeout
 100 to 10000 (seconds)
INITLOG The event log has
initialized.
EQPT NA NA
IPADDR The IMC Ethernet
address has changed.
EQPT 0.0.0.0 1.0.0.1 to 254.255.255.254
IPGATE
The IMC Ethernet gateway
address has changed.
EQPT 0.0.0.0 1.0.0.1 to 254.255.255.254
IPSUB The IMC Ethernet subnet
mask has changed.
EQPT 255.255.255.0 1.0.0.1 to 254.255.255.254
ISDIFF
Indicates that the CRC of
two Istates images stored
on separate modules are
different.
EQPT NA NA
ISEQ Indicates that the CRC of
two Istate images stored
on separate modules are
equal.
EQPT NA NA
Table C-1. Event Identifiers (Continued)
Event ID
or
CONDTYPE
Event Description
AID
TYPE
Default Value Value Description

Symmetricom TimeProvider 1100 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1100
Category	Clock
Language	English