097-58001-01 Revision E – September 2006 TimeProvider TL1 Reference Guide 49
Chapter 2 TL1 Command Syntax and Description
Edit Equipment (ED-EQPT)
<aid> = PRS
INSTATE ENABLE The specified input is enabled. DISABLE
DISABLE The specified input is disabled.
MONITOR
The specified input is in monitor-only mode.
Note: In monitor-only mode, the input is monitored for
signal faults and the performance of the input is
monitored, but the input cannot be selected as a system
reference or used as a BesTime backup reference.
<aid> = INPp
INSTATE ENABLE The specified input is enabled. ENABLE
DISABLE The specified input is disabled.
MONITOR The specified input is in monitor-only mode.
Note: In monitor-only mode, the input is monitored for
signal faults and the performance of the input is
monitored, but the input cannot be selected as a system
reference or used as a BesTime backup reference.
<aid> = OUTg
OUTSTATE ENABLE The specified output group is enabled. DISABLE
DISABLE The specified output group is disabled.
<aid> = E422g
OUTSTATE ENABLE The specified EIA-422 output group is enabled. DISABLE
DISABLE The specified EIA-422 output group is disabled.
<aid> = RTMg[-p]
RTMSTATE ENABLE The specified Retimer group is enabled. ENABLE
DISABLE The specified Retimer output group is disabled.
SLIPCLR NA Clears a current Slip alarm from the specified port. NA
Note: See Edit Sync (ED-SYNC), on page 55 for more provisioning
parameters.
Table 2-5. ED-EQPT – Keywords and Values (Continued)
<keyword> <value> Description Default
To Next Page
Loading...
Need help?
General
