ALGORITHMS
M5ALGOIN
Rev 1.4 Page 20
menu under UTIL before setting this
control. If the red overload LED still
flashes, turn down INLEV a couple of
dBs. The control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
OUTLEV off - 0.0 dB. Sets the output level of the program in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the chorus algorithm to output
maximum signal to the D/A converters.
It affects the output PPM reading. There
is a separate output level control for
adjusting the analog output level in
UTIL. Set the analog input (if you use
analog input) and the INLEV
adjustments before setting OUTLEV.
This control does not affect the
bypassed signal level. Normally, you do
not have to change the factory default
setting.
PHASE 0º - 90º - 180º Determines the sine wave modulation
phase shift between left and right
channels. At 0º the left and right
modulation will move in sync. At 180º
the modulation will move the channels
against each other.
DELAY 0 - 670 mS (Idx=32K) Controls the length of delay time.
0 - 1.360 mS (Idx=64K) Max delaytime. Depends on the index
RAM in the machine (also called high
memory). Check how much index RAM
you have in the utility menu CONFIG.
FEEDBACK 0 - 99 % Controls the amount of effect signal
routed back to the chorus input
(Flanging).
SPEED 0.1 Hz - 10 Hz Controls the rate of sweep in a range
from 1 sweep every 10 seconds to 10
sweeps every second.
DEPTH 0 - 100 % Determines how wide a modulation
(sweep) is produced.
To Next Page
Loading...
Need help?
General
