ALGORITHMS
M5ALGOIN
Rev 1.4 Page 24
level. Set the analog input (if you use
analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level. Normally, you do not have
to change the factory default setting.
PAGE 2:
PITCH 1 -12 - 12 Transposition for pitch shifter 1. One
step corresponds to a semitone (one half-
step). 0 corresponds to no pitch shift and
12 or -12 is equal to one octave up or
one octave down.
FINE 1 -50 - 50 Fine adjustment of pitch shifter 1. When
set to 0 there is no fine adjustment. -50
or 50 is equal to one semitone down or
up.
PITCH 2 -12 - 12 Transposition for pitch shifter 2. One
step corresponds to a semitone (one half-
step). 0 corresponds to no pitch shift and
12 or -12 is equal to one octave up or
one octave down.
FINE 2 -50 - 50 Fine adjustment of pitch shifter 2. When
set to 0 there is no fine adjustment. -50
or 50 is equal to one semitone down or
up.
PAGE 3:
LEVEL 1 off - 0.0 dB In order to match the balance between
the 2 pitches or/and the original (dry)
signal LEVEL 1 sets the level on PITCH
1 only.
PAN 1 50L - center - 50R PAN separates the pitches between left
and right. When PAN 1 is set to "50L"
the PITCH 1 will appear in the
left
side.
LEVEL 2 off - 0.0 dB Like LEVEL 1, LEVEL 2 sets the level
on PITCH 2 instead.
PAN 2 50L - center - 50R When PAN 2 is set to "50R" the PITCH
2 will appear in the
right
side.
PAGE 4:
HICUT 1 500 Hz - flat High cut filter, shelving type for PITCH
1. Provides an overall high frequency
To Next Page
Loading...
