ALGORITHMS
M5ALGOIN
Rev 1.4 Page 42
STANDARD OR SIMM SAMPLER:
With software version 1.15 the SAMPLE-1 is implemented in a full featured version. All you
have to do is to install some SIMM memory modules (CONFIGURATION Section, SIMM
INSTALLATION module). When no SIMM memory is installed the so called STANDARD
SAMPLER will be active and some parameters may be adjusted but has no effect. As soon
SIMM is installed the SIMM SAMPLER will be active and all parameters will be fully
available. The inactive parameters in the STANDARD SAMPLER will in the following be
marked with (
*
).
PROGRAM PARAMETERS
*
:
When storing a sample preset no sound is actually saved, only a number of setup parameters
for use when recording and playing back samples. A SAMPLE-1 preset holds the following
parameters:
MIX, INLEV, OUTLEV, RECMODE, FIL-RES, FADEIN, FADEOVR, TRIGGER,
TRIGLEV, DEADBND and RETRIG.
Note that recalling another preset merely changes the current setting of these parameters.
SAMPLE PARAMETERS:
The following parameters are attached to each sample and are also kept with the individual
sample when saving to/loading from disk.
RECMODE, REVERSE, LEVEL, PAN, filter settings, MIDIkey, NOTEoff and VELsens.
EDIT PARAMETERS:
MIX 0 - 100 % Sets the mix between direct and sampled
signal. In order to monitor the input
signal, press the bypass button. MIX can
be set to 100% globally in the G-
LEVELS-menu under UTILITY. Set
MIXMODE
WET=MAX
and all direct
signals are "killed" regardless of preset
mix settings.
INLEV off - 0.0 dB. Sets the level of the input to the sampler
in 0.5 dB steps. The function of the
control is to maximize dynamic range.
Please note that this control is positioned
after the input PPM meter, and will not
affect the input PPM reading. Also when
using an analog input, make the analog
input adjustment in the G-LEVELS-
menu under UTIL before setting this
To Next Page
Loading...
Need help?
General
