ALGORITHMS
M5DYN
Rev 1.1 Page 7
PAGE 3:
TAP 1 -18 Selects the tap to be adjusted. Select 1 to
edit the first tap. Then turn dial "A" one
click to the right to edit the no. 2 etc. All
18 taps can be edited according to
LASTTAP.
DELAY 0 - 624 ms Sets the delay time for the selected TAP.
LEVEL 0 - 100 % Sets the level of the selected TAP.
PAN
----------|----------
Sets the panning of the selected TAP.
PAGE 4:
LOCUT 20 Hz - 1.00 KHz Low cut filter, shelving type. Provides an
overall low frequency rolloff (6 dB per
octave). Sets the cutoff frequency of the
overall high cut filter in 1/3-octave steps.
ATT -40 - 0.0 dB The attenuation control sets the low
frequency roll determined by LOCUT.
HICUT 1.00 KHz - flat High cut filter, shelving type. Provides
an overall high frequency rolloff (6 dB
per octave). Sets the cutoff frequency of
the overall high cut filter in 1/3-octave
steps.
ATT -40 - 0.0 dB The attenuation control sets the high
frequency roll determined by HICUT.
PAGE 5:
SPEED 0.100 - 10 Hz Adding modulation to the taps has the
effect of smoothing out the frequency
response, by effectively averaging out
the resonances. Detuning of the created
space will result from the use of this
parameter so use judiciously.
DEPTH 0 - 100 % Determines how wide a modulation
(sweep) is produced.
To Next Page
Loading...
Need help?
General
