ALGORITHMS
M5DYN
Rev 1.1 Page 6
Normally you do not have to change the
factory default setting.
OUTLEV off - 0.0 dB. Sets the output level of the algorithm in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the TAPFAC algorithm to
output maximum signal to the DA
converters. It affects the output PPM
reading. There is a separate output level
control for adjusting the analog output
level in UTIL. Set the analog input (if
you use analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level. Normally you do not have to
change the factory default setting.
PAGE 2:
SCALE 0 - 100 % Sets the relative spacing of the taps to
allow the scaling of 'x SIZE' of the space
created. Example: With four taps set at
11, 13, 15 and 17ms and the SCALE set
at 50% the actual tap lengths are 5.5, 6.5,
7.5, and 8.5ms. This parameter is
extremely useful because it changes all
18 taps simultaneously without having to
do individual tap adjustments.
PREDLY 0.0 - 100.0 mS Sets the time that passes before the first
tap appears. Increasing the predelay will
change the apparent position and, to
some degree, the size of the room.
WIDTH 0 - 100 % Sets the apparent stereo width of the
taps. At '0' all taps will appear to be
coming from the center (mono), whereas
with WIDTH set to '100%' the taps
appear at the L/R positions set by the
PAN parameter.
LASTTAP 1 - 18 Selects the amount of active taps starting
from 1. When set to 18 all 18 taps are
active.
To Next Page
Loading...
Need help?
General
