ALGORITHMS
M5DYN
Rev 1.1 Page 9
EDIT PARAMETERS:
MIX 100 % Locked in 100% wet mode.
INLEV off - 0.0 dB. Sets the level of the input to the
algorithm in 0.5 dB steps. The function
of the control is to maximize dynamic
range. Please note that this control is
positioned after the input PPM meter,
and will not affect the input PPM
reading, also if using an analog input,
make the analog input adjustment in the
G-LEVELS-menu under UTILITY
before setting this control. However, if
the red overload LED flashes, turn down
INLEV a couple of dBs. The control
does not affect the bypassed signal level.
Normally you do not have to change the
factory default setting.
OUTLEV off - 0.0 dB. Sets the output level of the algorithm in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the algorithm to output maxi-
mum signal to the DA converters. It
affects the output PPM reading. There is
a separate output level control for
adjusting the analog output level in
UTILITY. Set the analog input (if you
use analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level.
PAGE 2:
LO-EQ off, on Switches the low-EQ filter off and on.
MID-EQ1 off, on Switches the mid-EQ1 filter off and on.
MID-EQ2 off, on Switches the mid-EQ2 filter off and on.
HI-EQ off, on Switches the high-EQ filter off and on
To Next Page
Loading...
Need help?
General
