ALGORITHMS
M5DYN
Rev 1.1 Page 18
MIX 100 % Locked in 100% wet mode.
INLEV off - 0.0 dB. Sets the level of the input to the dynamic
algorithm in 0.5 dB steps. The function
of the control is to maximize dynamic
range. Please note that this control is
positioned after the input PPM meter,
and will not affect the input PPM
reading, also if using an analog input,
make the analog input adjustment in the
G-LEVELS-menu under UTIL before
setting this control. However, if the red
overload LED flashes, turn down INLEV
a couple of dBs. The control does not
affect the bypassed signal level.
Normally, you do not have to change the
factory default setting.
OUTLEV off - 0.0 dB. Sets the output level of the algorithm in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the dynamic algorithm to
output maximum signal to the DA
converters. It affects the output PPM
reading. There is a separate output level
control for adjusting the analog output
level in UTIL. Set the analog input (if
you use analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level.
BALANCE 50 L - center - 50 R Adjusts the balance between L and R
signal.
PAGE 2:
LOWCUT off - 200 Hz Filters out sub-bass frequencies and any
DC component found in the audio signal.
WARNING
: If this is set to
off
you
must be very sure that no DC offset is
present in the signal as this can interfere
with the low level function of this
algorithm.
LM-XOVR low off - 16.00 KHz The DYNAMIC1 algorithm is separated
into 3 bands. LM-XOVR sets the
crossover point between low- and
To Next Page
Loading...
