ALGORITHMS
M5DYN
Rev 1.1 Page 19
midband frequencies. When set to
low
off
the algorithm is split in 2 bands.
MH-XOVR mid off - 16.00 KHz Sets the crossover point between
midrange and high band frequencies.
When set to
mid off
the algorithm is a
fullband compressor/limiter and is
controlled with softdial D. MH-XOVR
can not overlap LM-XOVR.
fig. 3
SOFTCLP on - off Soft clipping. Smoothly kills any
overshoot that might occur after heavy
compression or limiting. Please note that
if you drive it too hard (with OUTLEV at
0dB and too much plus gain in the BND-
LVL controls, you might introduce
noticeable distortion, on signals with a
low harmonic content and/or on very
pure signals). The distortion introduced
is somewhat similar to the tape
saturation kind of distortion that happens
in an analog tape recorder.
To Next Page
Loading...
