3-25
Fig. 3.81
Fig. 3.84
Fig. 3.83
Fig. 3.82
■REASSEMBLING TRANSMISSION
① Install the suction pipe (1) on the transmission
case. (for 43E-25 only)
Note: The suction pipe (1) is not used with the
44E-25.
② Install the counter gear (1) in the transmission
case.
③ Install the clutch packs (2, 3) and output gear
(1) in the transmission case.
Note: Make sure that each clutch pack has a seal
ring on their shaft end.
④ With a gasket (1), install the control valve (2)
on the transmission case.
To Next Page
Loading...
