Technifor T08

31
M_T08_EN_B
Menu: Edit 󰘰le
Special situation
It is possible that the center of the circle is located outside the marking zone. In this case, the X and Y
coordinates are superior or inferior to the marking area. Check that the text to be marked is within the marking
area.
Example of a circle outside the marking area (Impact):
20 40
40
20
60
60 80
80
100
100
120
1
1. Marking area: 120 mm (4.724 in) x 100 mm (3.937 in)
2. Angle: 160°
3. Radius: 50 mm (1.969 in)
 Shapes
• Logos
Used to mark the logos saved in the CCU.
The screen below appears:
List of available logos: to drop down the menu, press the arrow. Select the option required.