Technifor T08

24
M_T08_EN_B
Menu: Marking
2. "In󰘰nite" marking
It is a marking mode similar to "N times" except that the marking is repeated in󰘰nitely. Marking continues
unless an error is detected.
Choose the 󰘰le to be marked. Select "In󰘰nite".
Start marking: press the "Start marking" icon.
If the text to be marked is o󰘯-limits, an error message appears on-screen (Menu: Settings - Marking settings -
O󰘯-limits control: Activated parameter).
To stop marking, press the "Stop marking" icon. Marking is stopped.
3. "Independent" marking
Used to obtain markings identical to those in "In󰘰nite" mode, the only di󰘯erence being that when the machine is
switched back on after an interruption during marking (reset, power outage...) marking is resumed by pressing
on "Start marking".
Choose the 󰘰le to be marked. Select "Independent".
Start marking: press the "Start marking" icon or press the trigger on the machine.
If the text to be marked is o󰘯-limits, an error message appears on-screen (Menu: Settings - Marking settings -
O󰘯-limits control: Activated parameter).
To stop marking, press the "Stop marking" icon. Marking is stopped.