Technifor T08

46
M_T08_EN_B
Menu: Edit 󰘰le
 Character size
The "Size" 󰘰eld de󰘰nes the actual height, in either millimeters or inches, of characters marked in capital letters.
The size can range from 0.5 mm (0.020 in) to 45 mm (1.772 in) (with an accuracy of 0.01 mm (0.01 in)).
The default value is 2.5 mm (0.10 in).
 Text angle
Used to de󰘰ne the angle at which the text is marked. See: Linear marking
The default value is 0°.
 Marking force
The width and depth of the marked line varies with the de󰘰ned value.
The higher the force, the deeper the mark. This value is expressed as a percent. The default value of the
"Force" area varies according to the machine's con󰘰guration.
1
1. Marking force