Technifor T08 - Goto; IF

66
M_T08_EN_B
Functions
7. Goto
Used to go directly to the required block in the same marking 󰘰le.
The screen below appears:
Number of block to reach
The program immediately starts marking the block indicated.
You cannot indicate an earlier block number in the 󰘰le (no going backwards).
To reach the end of the 󰘰le, enter the value 0.
8. IF
Used to add a condition for marking the 󰘰le. The screen below appears:
1
2
4
3
1. Type of condition
2. Values to compare
3. Type of comparator
4. Number of block to reach (if the condition is not ful󰘰lled)