Technifor T08 User Manual

47
M_T08_EN_B
Menu: Edit 󰘰le
 pause after a block
To enter other information, use the scroll bar.
To activate the pause after a block, press the corresponding symbol.
When this function is activated, the machine pauses after the block concerned.
1
2
3
4
8
7
6
5
1. Character font
2. Compression
3. Inclination
4. Spacing
5. Pause after a block
6. Alignment
7. Marking e󰘯ects
8. Marking direction
 Character font
The various fonts saved are identi󰘰ed by a number followed by their name. Go to the font area to select the
character font to be used in the marking block being prepared.
 List of available fonts:
• 0: Standard font
• 1: Standard EM font
• 2: Simpli󰘰ed font
• 3: 5x7 font
• 4: OCR-A font
• 5: OCR-B font
• 6: Scribing font
• 7: Double stroke font
• 8: Low density EM font
• 9: Medium density EM font
• 10: High density EM font
Note: for the list of characters available, contact Gravotech.

Technifor T08 Specifications

General

Brand	Technifor
Model	T08
Category	Controller
Language	English