Technifor T08

8
M_T08_EN_B
C. Introduction
Somescreenshotsmaybedi󰓐erentfromthosedisplayedintheprogram.
1. General characteristics of the program
The T08 standard marking program is integrated in a Control Unit, or in the main board of the machine (viewed
on an LCD screen). It is used to:
• Program 󰘰les for marking:
- set text
- variable text:
- date (using various set or customized formats)
- counter (incrementation, decrementation)
- logos...
2. Program functions
 Customization
• Multilingual: program language selection (communication interface, keyboard)
• Units (mm or inches)
 Type of blocks
• Marking:
- linear (choice of the angle)
- radial
• Logos
• 2D code
• Functions