Technogym DGK02U0 - Troubleshooting & Configuration; Procedure to Follow When Replacing Components; Replacing the Display (High Kit); Replacing the Drive (Low Kit)

6. TROUBLESHOOTING & CONFIGURATION
6.1 PROCEDURE TO FOLLOW WHEN REPLACING
COMPONENTS
6.1.1 REPLACING THE DISPLAY (HIGH KIT)
When replacing the display:
- Follow the LIVE display installation wizard that guides the user in the relative conguration;
- Enter the SN of equipment;
- Upgrade the display SW to the latest released version using the USB upgrade stick;
- Perform the standard settings procedure.
6.1.2 REPLACING THE DRIVE (LOW KIT)
When replacing the drive:
- Upgrade the FW to the latest released version using the USB upgrade stick;
- Perform the standard settings procedure.
6.1.3 REPLACING THE BELT MOTOR
Before replacing the belt motor:
- Upgrade the display SW to the latest released version using the USB upgrade stick;
- Upgrade the Low Kit FW to the latest released version using the USB upgrade stick.
After replacing the belt motor:
- Turn on the equipment, enter the 2501 menu and perform the standard settings procedure.
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
- 53 -TSG-00284-EN- Uncontrolled copy if printed