Check the resistance between the 3 phases of the belt motor:
PIN 1 - PIN 2 ~ 0.9 Ω (including the impedance of the tester)
PIN 1 - PIN 3 ~ 0.9 Ω (including the impedance of the tester)
PIN 2 - PIN 3 ~ 0.9 Ω (including the impedance of the tester)
[6]: Check the Vac of the 3 phases on the drive, with the tread belt moving.
The 3 values measured between:
▪ PIN 1 and the earth
PIN 1
EARTH
Fig. 51
▪ PIN 2 and the earth
▪ PIN 3 and the earth
must be the same (~ 220 Vac)
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
- 92 - TSG-00284-EN- Uncontrolled copy if printed
To Next Page
Loading...
