1502C MTDR Service Manual
xi
Service Safety Summary
Only qualified personnel should perform service procedures. Read this Service
Safety Summary and the General Safety Summary before performing any service
procedures.
Do not perform internal service or adjustments of this product unless another person
capable of rendering first aid and resuscitation is present.
To avoid electric shock, disconnect the main power by means of the power cord or
the power switch.
Dangerous voltages or currents may exist in this product. Disconnect power, remove
battery, and disconnect test leads before removing protective panels, soldering, or
replacing components.
To avoid electric shock, do not touch exposed connections.
This instrument contains a lead-acid battery. Some states and/or local jurisdictions
might require special disposition/recycling of this type of material in accordance
with Hazardous Waste guidelines. Check your local and state regulations prior to
disposing of an old battery.
Tektronix Factory Service will accept 1502C batteries for recycling. If you choose
to return the battery to us for recycling, the battery cases must be intact, the battery
should be packed with the battery terminals insulated against possible short-circuits,
and should be packed in shock-absorbant material.
Send batteries, post-paid, to:
Tektronix, Inc.
Attn: Bend Service
100 S.E. Wilson Ave.
Bend, OR 97702
For additional information, phone: 1–800–TEK-WIDE ext. 2400.
Do Not Service Alone
Disconnect Power
Use Care When Servicing
With Power On
Disposal of Batteries
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
