Options—2230 Service
Table 7-32
Event Codes
EVEnt? Code
Instrument Status
000
No status to report
Command Errors
101
102
103
104
105
Command header error.
Header delimiter error.
Command argument error.
Argument delimiter error.
Non-numeric argument, numeric expected.
106
107
108
109
Missing argument.
Invalid message-unit delimiter.
Checksum error.
Byte-count error.
151
152
153
154
155
The argument is too large.
Illegal hex character.
Non-binary argument; binary or hex expected.
Invalid numeric input.
Unrecognized argument type.
Execution Errors
201
203
205
206
Command cannot be executed when in LOCAL.
I/O buffers full, output dumped.
Argument out of range, command ignored.
Group execute trigger ignored.
251
252
253
254
255
256
258
259
260
261
262
263
Illegal command.
Integer overflow.
Input buffer overflow.
Invalid waveform preamble.
Invalid instrument state.
GPIB (Option 10) Command not allowed.
Command not allowed on a 2220.
Command not allowed on a 2230.
Cannot execute command with RQS OFF.
Reference memory busy with local (front-panel) command.
Reference memory non-existent or specified as different size than selected waveform.
Plot active; only PLOT ABORT allowed while plotting.
Internal Errors
351
Firmware failure. Contact your nearest Tektronix Service Center for assistance.
7-36
To Next Page
Loading...
Need help?
General
