Section 9— 2230 Service
•7*'
DIAGRAMS AND CIRCUIT BOARD ILLUSTRATIONS
Symbols
Graphic symbols and class designation letters are
based on ANSI Standard Y32.2-1975.
Logic symbology is based on ANSI Y32.14-1973 in
terms of positive logic. Logic symbols depict the logic
function performed and may differ from the manufac
turer’s data.
The overline on a signal name indicates that the signal
performs its intended function when it is in the low state.
Abbreviations are based on ANSI Y1.1-1972.
Other ANSI standards that are used in the preparation
of diagrams by Tektronix, Inc. are:
Y14.15, 1966 Drafting Practices.
Y14.2, 1973 Line Conventions and Lettering.
Y10.5, 1968 Letter Symbols for Quantities Used in
Electrical Science and E lectrica l
Engineering.
American National Standard Institute
1430 Broadway
New York, New York 10018
Component Values
Electrical components shown on the diagrams are in
the following units unless noted otherwise:
Capacitors = Values one or greater are in picofarads (pF).
Values less than one are in microfarads
m -
Resistors = Ohms (O).
The information and special symbols below may appear in this manual.
Assembly Numbers and Grid Coordinates
Each assembly in the instrument is assigned an
assembly number (e.g., A20). The assembly number
appears on the circuit board outline on the diagram, in the
title for the circuit board component location illustration,
and in the lookup table for the schematic diagram and
corresponding component locator illustration. The
Replaceable Electrical Parts list is arranged by assemblies
in numerical sequence; the components are listed by
component number *(see following illustration for
constructing a component number).
The schematic diagram and circuit board component
location illustration have grids. A lookup table with the
grid coordinates is provided for ease of locating the
component. Only the components illustrated on the facing
diagram are listed in the lookup table. When more than
one schematic diagram is used to iil ustrate the circuitry on
a circuit board, the circuit board illustration may only
appear opposite the first diagram on which it was il
lustrated; thelookup table will list the diagram number of
other diagrams that the circuitry of the circuit board
appears on.
F u nctio n B lo ck Title
E tch e d C ircu it B o ard
O utlin e d in Black
R e fer to W avefo rm
A sse m bly N u m ber
T ek tro n ix P art No.
for c irc u it bo a rd s
M o d i f i e d C o m p o n e n t
(D ep icted in G rey , o r W ith
G re y O utlin e ) • S ee P arts List.
S tra p o r L ink
P lug to E C . B oard
_
__
I B o x l- Id e n tifies P an e l
C o ntr o ls. C o n n e c to rs a n d
In dic ato rs
C o a x ial co n ne cto rs:
------
m a le
fem ale
P lu g In de x ; sig n ifie s pin Np. 1
|V a i. O ] — E x tern al S crew d riv er A dj.
S h ie ld in g
S e le c te d v alu e , s ee P a rts L is:
a n d M a in te na n c e S ec tio n fo r
S elec t io n C rite ria
D e c o u p le d o r F iltere d
V o ltag e
R efe r to D ia g ram N um b er
S c h e m a tic N a m e
a n d N um b er
To Next Page
Loading...
