Commands Listed in Alphabetical Order
AUXIn:PRObe:
GAIN? (Query Only)
This query-only command returns the gain factor of the probe that is attached to
the AUX In input. The “gain” of a probe is the output divided by the input transfer
ratio. For ex
ample, a common 1 0x probe has a gain of 0.1.
Group
Vertical
Syntax
AUXIn:PRObe:GAIN?
Examples
AUXIN:PROBE:GAIN? might return :AUXIN:PROBE:GAIN 0.1000E+00,
indicating that the attached 10x probe delivers 0.1 V to the AUX In BNC for
every 1.0 V applied to the probe input.
AUXIn:PRObe:ID:SERnumber? (Query Only)
This query-only command returns the probe serial number.
Group
Vertical
Syntax
AUXIn:PRObe:ID:SERnumber?
Example
s
AUXIN:PROBE:ID:SERNUMBER? might return :AUXIN :PROBE:ID:SERNUMBER
“B999999”
, indicating that the probe serial number is set to B999999.
AUXIn:PRObe:ID:TYPe? (Query Only)
This q
uery-only command returns the probe type.
Group
Vertical
Syntax
AUXIn:PRObe:ID:TYPe?
Examples
AUXIN:PROBE:
ID:TYPE?
might return :AUXIN:P ROBE:ID:TYPE “TAP1500”,
indicating that the probe type is set to TAP1500.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-91
To Next Page
Loading...
Need help?
General
