Commands Listed in Alphabetical Order
DATa:FRAMESTA
Rt
? might return :DATA:FRAMES TART 214 indicating the
first waveform frame that will be transferred.
DATa:FRAMESTOP
This command sets or queries the e nding data frame for waveform transfer. This
command allows for transferring partial frames of the waveform to and from
the instrument.
Group
Waveform Transfer
Syntax
DATa:FRAME
STOP <NR1 >
DATa:FRAMESTOP?
Arguments
<NR1> is the last data frame that is transferred, which ranges from 1 to the
number of a cquired frames. If <NR1> is greater than the number of acquired
frames, then you will receive up to the number of acquired frames. If both
DATA:FRAMESTART and DATA:FRAMESTOP are greater than the number of
acquired frames, then you will receive the last acquired frame. If no frames were
acquired, then you receive the first frame which contains all nulls.
DATA:FRAMESTART and DATA:FRAMESTOP are order independent. The smaller
number is used as in CURVe and SAVe:WAVEform queries.
To always transfe r complete waveforms , set
DATA:FRAMESTART to1and
DATA:FRAMESTOP to the maximum number of acquired frames, or larger.
Returns
The last data frame that will be transferred.
Examples
DATa:FRAMESTOP 1500 specifies that the waveform transfer will stop with
frame 1500.
DATa:FRAMESTOP
? might return :DATA:FRAMESTOP 14900 indicating the
last waveform frame that will be transferred.
DATa:SOUrce
This command sets or queries the location of waveform data that is transferred
from the instrument by the CURVe?Query.
Group
Waveform Transfer
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-157
To Next Page
Loading...
Need help?
General
