Commands Listed in Alphabetical Order
Examples
WFMOUTPRE:NR_
PT?
might return :W FMOUTPRE:NR_PT 5000, indicating that
there are 5000 data points to be sent.
WFMOutpre:PT_Fmt? (Query Only)
This query-only command returns the point format for the waveform specified by
the DATa:SOUrce command. The format specifies a set of equations describing
how the scale factors in the preamble are used to give meaning to the CURVe
data point
s.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Fmt?
Related Commands
CURVe, DATa:SOUrce
Examples
WFMOUTPRE:PT_FMT? might return :WFMOutpre: PT_Fmt ENV, indicating that
the waveform data is a series of min-ma x pairs.
WFMOutpre:PT_Off? (Query Only)
This query-only command returns the trigger point relative to DATa:STARt for
the waveform specified by the DATa:SOUrce command.
NOTE. This returned value is the point immediately following the actual trigger.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Off?
Related Commands
DATa:SOUrce, DATa:STARt, WFMOutpre:XZEro?
Examples
WFMOUTPRE:PT_OFF? might return :WFMOUTPRE:PT_OFF 251 specifying that
the trigger actually occurred between points 250 and 251.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-643
To Next Page
Loading...
Need help?
General
