Tektronix DPO7000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Conditions
This command is
valid only if the instrument has Option MTM is installed.
Group
Trigger
Syntax
TRIGger:A:COMMunication:CO De
{AMI|HDB3|B3ZS|B6ZS|B8ZS|C MI|NRZ|MLT3|MANChester}
TRIGger:A:COMMunication:CO De?
Arguments
AMI
HDB3
B3ZS
B6ZS
B8ZS
CMI
NRZ
MLT3
MANChester
Examples
TRIGGER:A:COMMUNICATION:CO DE AM I sets the AMI as the line code that the
communications trigger expects on the incoming signal.
TRIGGER:A:COMMUNICATION:CO DE? might return
:TRIGGER:A:COMMUNICATION:C ODE AMI, indicating that the code is AMI.
TRIGger:A:COMMunication:SOUrce
This command sets or queries the source channel.
Conditions
This command is valid only if the instrument has Option MTM is installed.
Group
Trigger
Syntax
TRIGger:A:COMMunication:SO Urce {CH1|CH2|CH3|CH4}
TRIGger:A:COMMunication:SO Urce?
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-561

Tektronix DPO7000 Series Specifications

General

Brand	Tektronix
Model	DPO7000 Series
Category	Test Equipment
Language	English