Commands Listed in Alphabetical Order
Syntax
CH<x>:LABel:X
POS <NR1>
CH<x>:LABel:XPOS?
Arguments
<NR1> is the location (control in divisions) where the waveform label for the
selected channel is displayed, relative to the left edge of the screen. Arguments
should be integers ranging from 0 through 10.
Examples
CH3:LABEL:XPOS 5 moves the waveform label for the Channel 3 that it begins 5
divisions to the right of the left edge of the screen.
CH2:LABEL:XPOS? might return :CH2:LABEL:XPOS 5, indicating that the
waveform label for the Channel 2 currently 5 divisions to the right of the left
edge of the screen.
CH<x>:LABel:YPOS
This command sets or queries the Y screen offset at which the label (attached to
the displayed waveform of the specified channel) is displayed, relative to the
waveform handle. The channel is s pecified by x. The value of x can range from 1
through 4. This command is equivalent to selecting Label from the Vertical menu
and either viewing or setting Y Pos.
Group
Vertical
Syntax
CH<x>:LABel:YPOS <NR1>
CH<x>:LABel:YPOS?
Arguments
<NR1> is the location (in divisions) where the waveform label for the selected
channel is displayed, relative to the waveform handle. Arguments should be
integers ranging from 10 to -10.
Examples
CH3:LABel:YPOS -2.5 moves the waveform label for the Channel 3 2.5
divisions below the waveform handle.
CH2:LABel:YPOS? might return :CH2:LABEL:YPOS 0, indicating that the
waveform label for the Channel 2 is currently located at the waveform handle.
CH<x>:OFFSet
This command sets or queries the vertical offset for the specified channel. The
channel is specified by x. The value of x can range from 1 through 4. This
command is equivalent to selecting Offset from the Ve rtical menu.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-113
To Next Page
Loading...
Need help?
General
