Tektronix DPO7000 Series Programmer's Manual

Commands Listed in Alphabetical Order
TRIGger:A:SE
RIAL:CLOCk:SOUrce
This command sets or queries the serial data source channel.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SERIAL:CLOCk:SO Urce {CH1|CH2|CH3|CH4|RECOVered }
TRIGger:A:SERIAL:CLOCk:SO Urce?
Arguments
CH1-4 specifies one of the input channels.
RECOVERED specifies clock polarity and level are extracted from the serial data
stream and other clock parameters are ignored.
Examples
TRIGGER:A:SERIAL:CLOCK:SO URCE CH1 sets the serial source channel to
CH1.
TRIGGER:A:SERIAL:CLOCK:SO URCE? might return
:TRIGGER:A:SERIAL:CLOCK:S OURCE CH3, indicating that the serial source
channel is set to CH3.
TRIGger:A:SERIAL:CODe
This command sets or queries the signal code.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SERIAL:CODe {NRZ|S8B10B}
TRIGger:A:SERIAL:CODe?
Arguments
NRZ sets the code to NRZ.
S8B10B sets t
he code to S8B0B.
Examples
TRIGGER:A:SERIAL:CODE NRZ sets the signal code to NRZ.
TRIGGER:A:SERIAL:CODE? might return :TRIGGER:A:SERI AL:CODE
S8B10B
, indicating that the signal code is set to S8B0B.
2-582 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO7000 Series Specifications

General

Brand	Tektronix
Model	DPO7000 Series
Category	Test Equipment
Language	English