Commands Listed in Alphabetical Order
Group
E-mail
Syntax
EMail:MASK {ON|OFF|<NR1>}
EMail:MASK?
Arg
uments
ON argument enables sending e-mail when a mask test failure occurs.
OFF disables sending e-mail when a mask test failure occurs.
<NR1> = 0 disables sending e-mail when a mask test failure occurs; any other
value enables sending e-mail when a mask test failure occurs.
Examples
EMAIL:MASK 1 enables sending e-mail when a mask test failure occurs.
EMAIL:MASK? might return :EMAIL:MASK 0, indicating that e-mail will not be
sent when a mask test failure occurs.
EMail:MAXSize
This command sets or queries the maximum size (in megabytes) of e -mail that can
be sent to the SMTP server.
Group
E-mail
Syntax
EMail:MAXSize {<NR1>}
EMail:MAXSize?
Arguments
<NR1> can be 0 through 2000 (megabytes). This is the maximum size of each
e-mail that can be sent to the SMTP server.
Examples
EMAIL:MAXSIZE 5 sets the maximum size of each e-mail enclosure to
5 megabytes of data.
EMAIL:MAXSIZE? might return :EMAIL:M AXSIZE 10, indicating that each
e-mail sent to the SMTP server can contain up to 10 megabytes of data.
EMail:MEASUrement
This command sets or queries whether measurement data is included as an
attachment to e-mail. You must specify the saved measurement selection and the
measurement format usi
ng the Email on Event setup menu. There are no remote
commands for this purpose.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-205
To Next Page
Loading...
Need help?
General
