Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre?
Examples
WFMOUTPRE? ? might return the waveform formatting data as:
:WFMOUTPRE:BIT_NR 8;BN_FMT RI;BYT_NR 1; BYT_OR MSB;ENCDG
BIN;NR_PT 5
00; PT_F MT Y;PT_ORDER LINEAR;PT_OFF 0; XINCR
8.0000E-9;XZERO 4.8794E-9; XUNIT "s";YMULT -2000.0000E-3 ;
YOFF -4 999.9995E-3;YZER O 0.0000;YUNIT "V"; WFID "Ch1, DC
coupling, 2.000V/div, 400.0ns/div,500 points, Sample mode"
.
WFMOutpre:BIT_Nr
This command sets and returns the number of bits per waveform point that
outgoing waveforms contain, as specified by the DATa:SOUrce command. Note
that values will be constrained according to the underlying waveform data. This
specification is only meaningful when WFMOutpre:ENCdg is se t to BIN and
WFMOutpre:BN_Fmt is set to either RI or RP.
Group
Waveform Transfer
Syntax
WFMOutpre:BIT_Nr <NR1>
WFMOutpre:BIT_Nr?
Related Commands
DATa:SOUrce, WFMOutpre:BN_
Fmt, WFMOutpre:ENCdg
Arguments
<NR1> number of bits per data point can be 8, 16, 32 or 64.
Examples
WFMOUTPRE:BIT_NR 16 sets the number of bits per waveform point to 16 for
incoming RI and RP binary format data.
WFMOUTPRE:BIT_NR? might return :WFMOUTPRE:BIT_N R 8, indicating that
outgoing RI or RP binary format data uses 8 bits per waveform point.
WFMOutpre:BN_Fmt
This command sets or queries the format o f binary data for outgoing waveforms
specified by the DATa:SOUrce command.
Group
Waveform Transfer
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-639
To Next Page
Loading...
Need help?
General
