Command Groups
Command
Description
CH<x>:LABel:YPOS Sets or returns the Y display c oordinate for
the channel waveform label
CH<x>:OFFSet Sets or returns the channel offset
CH<x>:POSition Sets or returns the channel vertical position
CH<x>:PRObe?
Returns the gain, resistance, units, and ID
of the probe that is attached to the specified
channel
CH<x>:PRO
be:AUTOZero
Autozeros
the probe attached to the specified
channel
CH<x>:PRObe:DEGAUSS Starts a degauss cycle of the probe attached
to the specified channel
CH<x>:PRObe:DEGAUSS:STATE?
Returns whether the probe attached to the
specified channel has been degaussed
CH<x>:PRObe:FORCEDRange Sets the attached probe to its default range,
or it ret
urns the default range of the probe
CH<x>:
PRObe:GAIN?
Return
s the gain of the probe that is attached
to the specified channel
CH<x>:PRObe:ID? Returns the type and serial number of
the probe that is attached to the specified
chann
el
CH<x
>:PRObe:ID:TYPe?
Retu
rns the type of probe that is attached to
the specified channel
CH<x>:PRObe:ID:SERnumber? Returns the serial number of the probe that
is attached to the specified channel
CH<x>:PRObe:INP UT M ode Sets or queries the input mode of the probe
tha
t is attached to the specified channel
CH
<x>:PRObe:INPUTMode:AOFFSet
Se
ts or queries the requested A mode offset
control of the probe that is attached to the
specified channel
CH<x>:PRObe:INPUTMode:BOFFSet Sets or queries the requested B mode offset
c
ontrol of the probe that is attached to the
specified channel
CH<x>:PRObe:INPUTMode:CMOFFSet Sets or queries the requested common mode
offset control of the probe that is attached to
the specified channel
CH<x>:PRObe:INPUTMode:DMOFFSet Sets or queries the requested differential
mode offset control of the probe that is
attached to the specified channel
CH<x>:PRObe:RANge Sets or returns the attenuation range of the
probe on the designated channel
CH<x>:PRObe:RESistance? Returns the resistance of the probe that is
attached to the specified channel
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-65
To Next Page
Loading...
Need help?
General
