Display Wavefor
mData
5. Push Bandwidth
, and select the desired
bandwidth on the resulting side menu.
The set choices are: Full and 20 MHz.
Additional ch
oices may appear, depending
on the probe that you use.
Select Fu ll to set the bandwidth to the full
oscilloscop
e bandwidth.
Select 20 MHz to set the bandwidth to
20 MHz.
6. Push Label to create a label for the channel.
(See page 45, Labeling Channels and
Buses.)
7. Push More to access additional side menus.
8. Select Fi
ne Scale to enable multipurpose
knob a to make fine vertical scale
adjustments.
Fine Scale
Offset
Positio
n
Probe
Setup
Deskew
9. Select Offset to enable multipurpose knob a
to mak
e vertical offset adjustments.
On the side menu, choose Set to 0 V to set
the vertica l offset to 0 V.
For m
ore information on offset, s ee Quick
Tips. (See page 93, Quick Tips.)
MSO3000 and DPO 3000 Series Oscilloscopes User Manual 91
To Next Page
Loading...
