Analyze Wavefor
mData
To manually set and clear (delete) marks:
1. Move (the zoom
box) to the area on the
waveform where you want to set (or
clear) a search mark by turning the pan
(outer) knob.
Push the next ( →) or previous (←)
arrowbuttontojumptoanexistingmark.
2. Push Set/Clear.
If no search
mark is at the screen center,
the oscilloscope will add one.
3. Investigate your waveform by moving
from search mark to search mark. U se
the next ( →
)orprevious(←)arrow
button to jump from one marked location
to another, without adjusting any other
controls
.
4. Delete a
mark. Push the next ( →)or
previous (←)arrowbuttontojumptothe
mark you want to clear. To remove the
current
, center-positioned mark, push
Set/Clear. It works on both manually
and automatically created marks.
To automatically set and clear (delete) search marks:
1. Push S
earch.
2. Select the search type desired on the lower
menu.
Search
Off
Search
Type
Edge
Source
1
Slope
Threshold
0.00V
The search menu is similar to the trigger
menu.
3. From the side menu, turn on the search.
MSO3000 and DPO 3000 Series Oscilloscopes User Manual 121
To Next Page
Loading...
