Application Exa
mples
To display the signals connected to channels 1 and 2:
1. Push channel 1 and channel 2 to activa te
both channels
.
2. Push Autoset.
To select me
asurements for the two channels:
1. Push Measu
re to see the measurement
menu.
2. Push Add Measurement.
Add Mea-
surement
Remove
Measure-
ment
Indicators
More
Bring
Cursors
On Screen
3. If need
ed, on the side menu, push Source
and turn multipurpose knob a to select
channel 1. Turn multipurpose knob b to
select
the Amplitud e measurement. Push
OK Add Measurement on the side menu.
Repeat this process to select channel 2 and
again
push OK Add M easurement on the
side menu.
MSO3000 and DPO 3000 Series Oscilloscopes User Manual 143
To Next Page
Loading...
