Get Acquainted w
ith the Instrument
6. Device. Use the U SB 2.0 High speed
device port to control the oscilloscope
through USBTM
CorGPIBwitha
TEK-USB-488 Adapter. The USBTMC
protocol allows USB devices to
communicate
using IEEE488 style
messages. This lets you run your G PIB
software applications on USB hardware.
Also, use the
USB port to connect a
PictBridge-compatible printer to the
oscilloscope.
7. Host. Use the USB 2.0 Full speed host
ports (one
on the rear-panel and one on
the front) to take advantage of USB flash
drives, keyboards, and printers.
8. Power input. Attach to an AC power line
with inte
gral safety ground. (See page 5,
Operating C onsiderations .)
MSO3000 and DPO 3000 Series Oscilloscopes User Manual 43
To Next Page
Loading...
