Operating basics
SIGNAL KEY ASSI
GN. Assigns signal sets to the front-panel test signal buttons
and assigns a frame picture file created by the Frame Picture Genera t or to the
OTHER test signal button. Select this menu item, and then press the ENTER
button to access the SIGNAL KEY ASSIGN submenu. (See page 2-37.)
LCD CONTRAST. Adjusts the contrast of the LCD display. Use the left (◄)or
right (►)ar
row button to dec rease or increase the display contrast.
BEEPER CONTROL. Enables or disables the beeper function in the instrument.
When enabled, the beeper alerts the us er when a fan fault condition h as been
detected. Use the left (◄)orright(►) arrow button to enable or disable the
beeper.
FRONT PANEL DISABLE. Sets the time-out period until the front-panel buttons are
disabled. Use the left (◄)orright(►) arrow button to select from the following
choices: Disable, Immediately, 1Minute, 10 Minutes, 30 Minutes,and1Hour.
Press the ENTER button to enable the selection.
When you select any of these time-out periods (exc ept Disable), the front-panel
buttons are disabled when that time passes without a button push. If this happens,
press and hold the FRONT PANEL ENABLE button for about 1 second to restart
the ti
me-out counter and enable the front-panel buttons.
The FRONT PANEL ENABLE button is illuminated when the front-panel buttons
are e
nabled.
NETWORK. Displays the current network parameters of the mainframe or sets the
network parameters for the 10/100/1000 BASE-T port o n the mainframe. Use the
left (◄)orright(►) arrow button to toggle between Information and Setup.
When you select Information and press the ENTER button, you will access the
NETWORK INFORMATION submenu. (See page 2-38.) When you select Setup
and press the ENTER button, you will access the NETWORK SETUP submenu.
(
Seepage2-39.)
TG8000 Multiformat Test Signal Generator User Manual 2–31
To Next Page
Loading...
Need help?
General
