GPS7 GPS Synchronization and Timecode modu le
GPS7 modu le
TIME ZONE OFFSET
submenu
Use this menu to
set the time zone offset for your location in reference to UTC.
Press the ENTER button, and then use the left (◄)orright(►) arrow button
to se lect a digit in the offset value to change. An underline character appears
under the selected o ffset digit. The date and time digits take the following form:
HH:MM.
After you select an offset digit, use the up (▲)ordown(▼) arrow button to
change the v
alue of the digit. Repeat for each digit as required for you offset.
Press the ENTER to confirm the offset change. The following figure shows the
TIME ZONE OFFSET submenu.
Figure 3
-64: GPS7 module TIME ZONE OFFSET submenu
NOTE. When the DST event occurs, the scheduled offset will be added to the time
zone offset, and the DST schedule will be cleared. This allows for a new schedule
to be set up for any time in the future.
The Offset adjustment allows you to enter a time zone correction of up to ±23:59
hours. However, the ST309 standard only implements codes for time zones in the
range of -12 to +13 hours. Therefore, when the G PS7 module is set to use ST309
data
as the Time of Day source, it is recommended that the combined programmed
offset from time zone and DST be restricted to the range of -12 to +13 hours.
3–138 TG8000 Multiformat Test Signal Generator User Manual
To Next Page
Loading...
Need help?
General
