Tektronix TG8000 User Manual

Getting started
4. Set the HD trile
vel sync rate to Integer on the GPS7 module:
a. Use the up (▲)ordown(▼) arrow button to select SELECT OUTPUT.
b. Use the left (◄)orright(►) arrow b utton to select HD TRI-LEVEL
SYNC RATE.
c. Press the ENTER button.
d. Use the left (◄)orright(►) arrow button to select Integer (60, 50, 30,
25, 24).
e. Press the ENTER button.
f. Press the BACK button to exit the HD Tri-level Sync Rate submenu.
5. Set Black 1 to NTSC on the GPS7 module:
a. Use the left (◄)orright(►)arrowbuttontoselectBlack 1.
b. Press the ENTER button.
c. Use the up (▲)ordown(▼) arrow button to select FORMAT.
d. Use the left (◄) or right (►) arrow button to select NTSC.
e. Press the ENTER button.
6. Check that the WFM8300 shows NTSC as the reference input.
7. Use the left (◄)orright(►)arrowbuttontoselect1080 60i in the Select
Format menu.
8. Press the ENTER button.
9. Check that the WFM8300 shows a 1080 60i s ignal on the reference input.
10. Disconnect the Black 1 signal from the module and the WFM8300.
11. Connect the Black 2 signal from the module to the r eference input of the
WFM8300.
12. Set Black 2 to a 1080 50i signal on the GPS7 module:
a.
Press the BACK button to exit the Black 1 submenu.
b. Use the left (◄)orright(►)arrowbuttontoselectBlack 2.
c. Press the ENTER button.
d. Use the left (◄)orright(►)arrowbuttontoselect1080 50i.
e. Press the ENTER button.
13. Check that the WFM8300 shows a 1080 50i signal on the reference input.
14. Use the left (◄) arrow button to select PAL.
15. Press the ENTER button.
TG8000 Multiformat Test Signal Generator User Manual 1–31

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English