Getting started
16. Use the left (◄)
arrow button to select Black Burst.
17. Press the ENTER button.
18. Check that the WFM8300 shows PAL on the reference input.
19. Press the BACK button to exit the PAL submenu.
20. Press the BACK button again to exit the Select Format submenu.
21. Disconnect the Black 2 signal from the module and the WFM8300.
22. Connect the Black 3 signal from the module to the reference input of the
WFM8300.
23. SetBlack3toaPALsignalontheGPS7module:
a. Use the right (►)arrowbuttontoselectBlack 3.
b. Press the ENTER button.
c. Use the right (►) arrow button to select PAL.
d. Press the ENTER button.
24. Check that the WFM8300 shows PAL on the reference input.
25. Use the left (◄)orright(►) arrow button to select 1080 24p.
26. Press the ENTER button.
27. Check that the WFM8300 shows 1080 24p on the reference input.
28. Press the BACK button to e xit the Select Formats menu.
Black output VITC.
1. Connect a cable from the Black 1 output on the module to the CMPST A input
on the WFM8300, and terminate the loop through with a 75 Ω terminator.
Activate the input by pressing the C input button on the front panel of the
monitor.
2. On the WFM8300, press the CONFIG button and select VITC as the timecode
source.
3. On the TG8000, press the MODULE button until GPS7 appears.
4. Use the up (▲)ordown(▼)arrowbuttontoselectSELECT OUTPUT.
5. Use the left (◄)orright(►) arrow button to select
Black 1.
6. Press the ENTER button.
7. Use the up (▲)ordown(▼) arrow button to select FORMAT.
8. Use the left (◄)orright(►) arrow button to selec t NTSC.
9. Press the ENTER button.
1–32 TG8000 Multiformat Test Signal Generator User Manual
To Next Page
Loading...
Need help?
General
