Tektronix TG8000 User Manual

Getting started
10. Use the up (▲)or
down (▼)arrowbuttontoselectTimecode.
11. Press the ENTER button.
12. Use the left (◄)orright(►) arrow button to select Time of Day as the
Timecode Source.
13. Press the ENTER button.
14. Use the up (▲) arrow to select the VITC submenu and press the ENTER
button to select VITC 1.
15. Press the right (►) arrow to select Output : Enable.
16. Press the ENTER button.
17. Use the down (▼) arrow to select Line number.
18. Press th
eleft(◄) arrow to select Line number: 14.
19. Check that the time of day is correctly updatingontheWFM8300Timecode
displa
y.
20. Repeat the procedure for Black 2 and Black 3 signals.
LTC output.
1. Connect the LTC/GPIO breakout adapter cable to the LTC/GPI DSUB on the
back
of the GPS7 module.
2. Construct an adapter by soldering wires between a female XLR and a 9-pin
DSU
B male header with solder cups, with this pin out:
a. XLRpin1toDSUBpin1.
b. XLRpin2toDSUBpin2.
c. XLRpin3toDSUBpin3.
3. Connect the LTC 1 output on the breakout cable to the XLR adapter you
just made.
4. Connect the DSUB end of the adapter you just made to the remote connector
on the WFM8300.
5. Configure the WFM8300 to use LTC as the Timecode source.
TG8000 Multiformat Test Signal Generator User Manual 1–33

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English