Getting started
6. Configure the LT
C 1 output of the GPS7 module for 30 fps drop frame:
a. Press the MODULE button until GPS7 appears.
b. Use the up (▲)ordown(▼) arrow button to select SELECT LTC.
c. Press the ENTER button to select LTC 1.
d. Use the up (▲)ordown(▼) arrow button to select Format.
e. Use the left (◄)orright(►) arrow button to select 30 fps drop frame.
f. Press the E
NTER button.
g. Use the up (▲)ordown(▼) arrow button to select Source.
h. Use the left (◄)orright(►) arrow button to select Time of Day.
i. Press the ENTER button.
7. Check that the time of day is correctly updating on the WFM8300 timecode
display.
8. Repeat this procedure for LTC 2 at 30 fps.
9. Repeat this procedure for LTC 3 at 25 fps.
10. Repea
t this procedure for LTC 4 at 24 fps.
GPI output.
1. Chec
k that the antenna signal is connected to the antenna input of the module
and that the instrument shows the signal is locked:
a. Pre
ss the MODULE button until GPS7 appears.
b. Use the up (▲)ordown(▼) arrow button, if needed, to select STATUS.
c. Check that the top line of the status display shows Locked.
2.
Connect the GPI 1 output to the voltmeter:
a. Connect the BNC-to-Banana-plug adapter to the voltmeter.
b. Connect the LTC/GPIO breakout adapter cable to the LTC/GPI DSUB
onthebackoftheGPS7module.
c. Connect the GPI 1 connector on the breakout cable to the
BNC-to-Banana-plug adapter.
1–34 TG8000 Multiformat Test Signal Generator User Manual
To Next Page
Loading...
