2.4. System Programming Sequence
After installing the AVA Wireless Alarm System control panel and performing a full reset,
there shall be no enrolled system devices, and its system parameters shall be set at
default values (for more information see also the Appendix: General Structure of System
Menus). In order to programme and prepare the system to operate after restart, it is
recommended to perform the following sequence of actions:
1. Install and enrol the wireless devices according to the algorithm (example) set in
§2.6.1 Enrolling of new devices, of this manual. It is obligatory to perform the described
radio test at the place of installation.
2. Programme the devices according to the needs (in case there is a difference from
the default parameters) by following the instruction in §3. It is recommended that each
device be given an individual name thus providing perspicuity to the system and easing
the user in understanding the status and performance of the devices – see Example of
Grouping sensor areas in §3.4, page 40.
3. Programme the Detector Groups according to the desired organization and functioning
of the system. For ease set the Groups names according to their functions.
4. Programme or modify the Arm and Disarm functions because they are operated by the
user and can also be activated from the buttons on the remote control.
5. Programme the necessary user codes and functions which have been assigned to
system activation rights and attributes.
6. If necessary programme the outputs.
7. If necessary change system parameters.
8. Do not forget to instruct the user how to operate the system and where necessary to
seek installation assistance.
2.5 Language Selection
During initial start-up the menus by default are in English. In order to change the menus
over to other language select in succession:
This enables prior access to the system parameters and the opportunity to select the
desired language. After selecting the indicated buttons the screen has the following
view:
You can choose the selected language by pressing the
To Next Page
Loading...
