Teletek electronics AVA - User Programming; Programming of User Codes, Names and Attributes

38 3. Programming
3.3 User Programming
The system supports 16 user codes with a 16 symbol name and parameters and one
engineer code with all programming rights. From the engineer code menu can not be
changed the User’s codes and their rights to bypass zones.
The manufacturer preset system codes are 0000 – for the Manager Code and 7777
– for the Engineer Code. Their values are automatically restored after completing a full
system reset.
To access the user programming menu press in succession:
3.3.1 Programming User Codes, Names and Attributes
The performance is as described in §3.1.2.
The menu is used to assign code owner rights where all at-
tributes of the Manager Code are enabled by default.
* All active parameters in the system are marked with the “*” symbol and the
inactive - with the “-” symbol. Press the
PRG
button of the keypad to change the
parameter status of the respective submenu.
Engineer
code-7777
Engineer Menu
Engineer Menu
)Codes Menu4
1
2
3
5
6789
4
Engineer
code-7777
4)Codes Menu
1)User Codes
ENT
Code 01 name
1)Change name
Code 01 ****
Code 01 name
ENT
ENT
Code 02 xxxx
Code 02 name
1)Change name
Code 01 name
-
Code 01 name
2)CodeAttributes
ENT
2
5
8
0
1
3
4
6
79
2)CodeAttributes
* Manager
* Manager
* Bypass
* Log view
* Time/Date Set
* Remote Access
****
õõõõ
programmed code
free position for
new code
*
1)Change name
2)CodeAttributes