Teletek electronics AVA - Keyboard Arming Procedures; Standard System Arming Steps

2. System Installation 9
Brick wall
Low Reduction
Steel Reinforced
Concrete
High Reduction
Low Reduction
High Reduction
2. System Installation
2.1 Wireless System Installation Basics
Planning the Installation. Situating and Selecting the Installation
Location.
In order to achieve the best efciency of the wireless system, prior to installation plan
the location of the control panel and the wireless devices within the premises. The
AVA Wireless System communicates two-way with all enrolled devices and therefore
it is advised to observe the following recommendations when selecting the installation
location.
1. Do not install the control panel in premises located below ground level - Figure 3.
Where this cannot be avoided, install the panel as high as possible.
Figure 3. Selecting the control panel
installation location.
2. Minimize the number of obstacles between the control panel and the wireless
devices – Figure 4.
Figure 4. Minimizing the number of
obstacles.
Figure 5. The construction and
the width of the walls between
the premises also affect the radio
signals transmitted between the
devices.