Teletek electronics AVA - Programming Backlight Turnoff Time and Generating of an Event for Mains Power Lost; System Option Programming; Software Version; Changing the Menu Language

3. Programming 45
3.6.5 Programming Backlight Turnoff Time and Generating of an Event for Mains
Power Lost
During a main electrical power failure for a longer time than programmed, the display
back light completely turns off to save the battery. The problem is visualized by the blink-
ing symbol
on the control panel.
In case of failure of the main power supply, the system generates an “EV_AC_LOST”
system event. It is sent to a monitoring system or by telephone line, which can be post-
poned in time in the interval of 0 - 255 minutes, in order to avoid indicating the problem
during short-term power failures.
The default programmed time for postponing the generation of an “EV_AC_LOST” sys-
tem event is 30 minutes.
Use the
ENT
button to conrm the entered time.
3.6.6 System Options Programming
The menu allows for “single-touch button operation”, i.e. quick arming without the re-
quirement of an user code. The messages to the communicator and the event memory
log during operation with single-touch functions are generated for user code 16 (there-
fore user code 16 has to be respectively programmed by assigning Arming Rights,
see AVA User Manual, User Programming).
The options “one touch menu” and “one touch ARM” have been activated by
default.
The activated option “Tamper on Lost” gives the possibility for generating a mes-
sage for open tamper-switch at lost device event. With the activated option “Tamper
disable” the system would not send messages for open tamper-switch of a device.
Use the
ENT
button to conrm the entered data and changes.
* All active parameters in the system are marked with the “*” symbol and the
inactive - with the “-” symbol. Press the
PRG
button of the keypad to change the
parameter status of the respective submenu.
3.6.7 Software Version
The system software version can be seen in the menu.
3.6.8 Language Menu
The AVA Control Panel supports different languages for the system menu. By default the
menus are in English.
Use the
ENT
button to conrm the entered language.
ENT
7)System
5)AC fault delay
5)ÀÑ fault delay
in minutes :30
2
5
8
0
1
3
4
6
79
-
* one touch menu
* one touch ARM
- Tamper on Lost
- Tamper disable
ENT
7)System
6)System options
6)System options
* one touch menu
ENT
7)System
7)Soft. Version
7)Soft. Version
ver.:ÕÕ
7)System
8)Language
8)Language
english
ENT
*