Teletek electronics AVA - Disarming Functions Programming

3. Programming 37
Programming is done by selecting the
PRG
button, as described
in §3 on page 20. Specify in the submenu which detector groups
are to be armed by the programmed function.
By default Function 1 has been programmed to arm Groups 1, 2 and 3 and
Function 2 – Groups 1, 2, 3, 4, 5 and 6.
When the system is armed where the Instant ARM option has been se-
lected, the Entry/Exit type groups shall be considered of an Instant type
and entry-exit time will not start - see also §3.4.
The output action is programmed in this menu when a function
is activated.
Programme the number of the programmable output, which is to
perform the action assigned in the previous menu.
All Arming functions (1 to 6) are programmed in an analogical manner.
3.2.2 Disarming Functions Programming
Programming follows the Arming functions.
By default Function 1 has been programmed to disarm Groups 1, 2 and 3
and Function 2 – Groups 1, 2, 3, 4, 5 and 6.
Programming follows the Arming functions.
Programming follows the Arming functions.
Use the
ENT
button to conrm all entered data and changes.
2)DisARMing
function N: 01
ENT
1)Group options
* Group 1
* Group 1
*2
*3
-4
-5
-6
-
Group
Group
Group
Group
Group
Duress event
funtion N: 01
1)Group options
function N: 01
2)PGM action
function N: 01
3)PGM Number
ENT
ENT
ENT
no action
Set
Reset
Change
Pulse2sec.
Pulse5sec.
Pulse 10 sec.
2)PGM action
no action
no PGM selected
PGM 1
PGM 2
PGM 3
PGM 4
3)PGM Number
no PGM selected
3)Functions
2)DisARMing
ENT
2)DisARMing
function N: 06
1)Group options
2)PGM action
3)PGM Number
1)Group options
2)PGN action
3)PGM Number